Three representative jobs. Drawings and quantities vary — these show the kind of work we handle.
| Material | Titanium alloy, 12 mm thick |
|---|---|
| Process | 5-axis waterjet, cold cut — no HAZ, no alpha-case layer |
| Tolerance | ±0.10 mm on profile; beveled mounting holes cut in the same setup |
| Why waterjet | Laser/EDM would harden or ignite titanium; waterjet keeps the edge metallurgically unchanged |
| Material | Carbon steel, 100 mm thick |
|---|---|
| Process | 3-axis abrasive waterjet, multi-pass |
| Result | Clean through-cut with minimal taper on a plate that plasma would warp |
| Why waterjet | No thermal distortion on thick stock; edge ready for welding after light dressing |
| Material | Stainless steel, 8 mm |
|---|---|
| Process | 5-axis waterjet profile + weld-prep bevel, then tapping at partner shop |
| Benefit | One source for the cut and bevel; secondary ops quoted separately and transparently |
| Note | Drilling/tapping/bending are not waterjet — we advise or outsource and state it on the quote |